Outdoor Wind Bells

How to Care for and Maintain Outdoor Wind Bells

How to Care for and Maintain Outdoor Wind Bells

The wind bells need maintenance periodically. This helps keep the sounds sharp and helps in keeping all the components in their good condition. In case of any bad weather approaching, one needs to examine the line, fittings, and bells and bring them inside.  

Even slight variation in sounds can also tell about the beginning of wear. Variation from clear sound to a dull sound can be seen even without wear and tear. In this blog, we’ll show you how to care for your wind bells.

How Do Wind Bells Wear in the Outdoors?

Start with the sun, because it gets to a bell first. It fades the finish (dark colours absorb the most heat, so they go first) and bakes the cord until it turns brittle. Rain is sneakier. It collects inside the bell body and rusts the clapper from within, so you won’t know until the note changes. By the coast, salt does the same to bare steel and iron at a quicker pace. Rinse coastal bells with fresh water after a salty blow. 

Then you’ve got the garden extras. Bird droppings are acidic and etch the finish, so wipe them clean as soon as you see it. Gum sap and pollen coat the rim. Mud wasps are the worst of the lot. One decides a hollow bell makes a fine nursery, and your lovely tone turns into a muffled thud until you clear it out. 

Regular wind bell maintenance includes knowing what to leave alone. Copper and bronze go brown or green with age, and that layer protects the metal underneath. Save the polish for bells you want bright.

What Cleaning Routine Keeps the Tone Clear?

Clean both the interior and exterior parts. Go for an overcast day as spots from the water get baked on when there is direct sunlight. You will use warm water and dishwashing soap to get the job done. For the grooves near the rim, you can use your old toothbrush. If the clapper loosens and comes off own its own, remove and clean it separately.  

First, rinse it with fresh water and dry with a clean cloth. Put it in the shade and let it dry completely before you hang it.

Metals differ, so each needs its own treatment:

Material 

Cleaning Approach 

Finish Protection 

Brass and bronze 

Mild soapy water, soft cloth 

Thin coat of paste wax slows tarnish 

Cast iron 

Brush off light rust, wipe dry 

Mineral oil or rust-resistant paint on bare spots 

Aluminium 

Mild soapy water, soft cloth 

No sealant needed 

Lacquered or coated 

Damp cloth, no polish 

Touch up chips with matching paint 

Apply wax to brass and bronze once the metal is dry, then buff until it feels smooth. If water stops beading, then it’s time to wax again. Good outdoor wind bell care follows a schedule. If you wait for the tone to go flat, you’ve waited too long. 

Where Do Cords and Fittings Fail Initially?

Cord is the Achilles heel of any bell, and everything hangs from it. Anyone learning how to care for wind bells should inspect it first. Wear shows up at the knot and where the cord rubs the hook.

Check these parts each season:

  • Cord, for fraying, stiff patches and flattened spots near the knot 
  • Clapper, for free swing and a clean strike on the bell wall
  • Clapper height, level with the bell wall, since a low or high clapper strikes with little force 
  • Hook and ring, for rust, bending and loose screws 
  • Wind catcher, for cracks and warping 

When you are changing the rope, use braided synthetic rope and stainless-steel hardware. The natural fibre will decay the minute it gets wet. Note the point at which the old knot was tied with the help of a pencil before you untie it. Match the old thickness too. Thick cord chokes the swing and thin cord saws through the hook. Give the new cord a firm tug before it carries the full weight. Add a safety line. Thin stainless wire from the bell body to the hook is enough. If the cord snaps, the bell stays hanging.

Seasonal and Storm Care for Wind Bells

Gusts twist the cord and slam the clapper into the bell wall. Cyclones and hail are worse. Taking bells down for a few days' costs nothing, so don’t gamble.

Use this checklist when the forecast turns nasty:

  • Take bells down before cyclones or hail 
  • Cover each one in soft cloth with a silica gel sachet and store it in a dry place 
  • Tap the bell with a soft hammer after hanging, and if you hear a buzzing sound, then your bell is cracked

Where you hang a bell cuts wind bell maintenance as well. Under an eave, wind bells get less exposure to rain and direct sunlight. Allow for enough space between the swing and the breeze. Finally, secure the swing to a sturdy beam or bracket, never to drywall. 

Care That Keeps Your Garden Singing

The right wind bell matters, and care does the rest. Keep a spare cord and hook in the shed, so a failed fitting doesn’t leave a bell on the ground. 

Give your garden the bells it deserves. Select a set from Gift N Garden and ensure that you care for your outdoor wind bell in the proper way. 

Reading next

How to Choose the Right Size Wind Chime for Your Space
How to Choose Wind Chime for Your Garden

Leave a comment

This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.